Slab Leak Repair in Plano starts with finding the exact leak before we break concrete. Our technicians use electronic leak detection equipment, acoustic listening devices, and thermal imaging cameras to pinpoint underground pipe leaks under your slab. Whether you have a warm spot on the floor, a high water bill, or foundation moisture, we fix the pipe and test the line before we leave. Call +1 (972) 544-0575.
Slab Leak Repair in Plano is the process of locating, accessing, and repairing a leaking water line or drain line that runs beneath your home's concrete foundation. We start with non-invasive detection: electronic leak detection equipment, acoustic listening devices, and thermal imaging cameras narrow the leak to within inches. Then we open a small access point, repair the copper pipe, PEX tubing, or PVC pipe, and patch the concrete with concrete patching compound. Every job ends with pressure testing to confirm the line holds.
Plano's expansive clay soil shifts with every wet and dry cycle, and that movement stresses underground pipes until they crack or separate. Homes in neighborhoods like Deerfield and Whiffletree, built mostly in the 1980s and 1990s, are now hitting the age where copper pipe corrosion and joint failures show up. If you search for slab leak repair Plano TX near me, you want a crew that knows these streets and these pipe systems. We do.
Every slab leak repair we do includes detection, repair, pressure testing, concrete patching, and cleanup. Each repair is checked carefully before we finish. Here is what is covered on a standard job. If your situation needs flooring removal or a full reroute, we quote that separately before we start.
We use electronic leak detection equipment, acoustic listening devices, and thermal imaging cameras to pinpoint the leak. Detection is included in every repair job. You get the exact location and a written summary before we cut concrete.
We repair or replace the failed section of copper pipe, PEX tubing, or PVC pipe using solder, pipe clamps, and pipe sealant as the material requires. If the pipe is too corroded to repair, we replace the section and tie it into the existing line.
Before we patch anything, we pressure test the repaired line at 80 to 100 PSI for 15 minutes. If it does not hold, we find out before your floor goes back down. This step is non-negotiable on every job we run.
We fill the access point with concrete patching compound and level it to match the surrounding slab. The patch is structural, not cosmetic. Once it cures, your flooring can go back down over it.
We bag debris, haul it off, and sweep the work area. You should not have to clean up after a plumber. If we tracked in dust or left concrete crumbs, we missed something, and we will come back and fix it.
We check the repair with you before we leave and walk you through what was fixed.
You call +1 (972) 544-0575 or book online. We ask about your symptoms: warm spots, high water bill, sound of running water with everything off, cracks in the slab. We schedule a visit at a time that works for you and confirm it by phone.
Our technician walks the slab with electronic leak detection equipment, acoustic listening devices, and a thermal imaging camera. We isolate the hot and cold lines with pressure testing kits and pipe locators. Most detections take 45 to 90 minutes. You get a written location and a clear explanation before any concrete is touched.
We show you the leak location and give you two or three repair paths: direct access repair, trenchless reroute, or epoxy pipe lining. Each option comes with a clear timeline and what it means for your floor and foundation. You pick. We do not start until you say go.
We cut a small access point, repair or replace the failed section of copper pipe, PEX tubing, or PVC pipe, and seal it with solder or pipe clamps and pipe sealant as the material requires. Then we pressure test the line at 80 to 100 PSI for 15 minutes. If it holds, we patch the concrete with concrete patching compound and backfill.
We haul off debris, sweep the work area, and leave your home cleaner than we found it. You get a summary of what was fixed and maintenance tips to protect the rest of your plumbing. Most jobs wrap in one day. Larger reroutes may run into a second day, and we tell you that upfront.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
We inject a signal into the suspect line and track it from above the slab. This pinpoints the leak to within inches without cutting concrete. It works on copper pipe, PEX tubing, and PVC pipe.
These amplify the sound of water escaping a pipe under the slab. We use them to confirm the leak location after electronic detection narrows the search area. Especially useful for small pinhole leaks.
Fluke thermal cameras show temperature differences on the floor surface. Hot water slab leaks show as warm streaks. We use them to trace the path of the leaking line before we cut.
For drain line leaks, we run a RIDGID SeeSnake camera through the pipe to see cracks, separations, and blockages. This confirms the leak and shows us the pipe condition before we repair.
We isolate sections of the plumbing system and pressurize them to confirm which line is leaking. We also use pressure testing after the repair to verify the fix holds at 80 to 100 PSI.
These locate buried pipes and trace their path under the slab. Knowing the exact pipe route lets us plan the smallest possible access cut and avoid hitting other lines.
When a pipe qualifies, we use trenchless equipment to reline or reroute the line with minimal concrete cutting. This avoids major demolition and shortens the job by days.
A Deerfield homeowner's water bill jumped from $95 to $210 in one month. No visible leak, no warm spots. They suspected a slab leak but two other plumbers wanted to jackhammer the living room floor without detection.
We used electronic leak detection and acoustic listening devices to find a pinhole leak in a copper cold water line under the hallway. We cut a 14-inch access point, replaced the section with PEX tubing, pressure tested at 90 PSI, and patched with concrete patching compound. Water bill returned to $92 the next cycle.
A West Plano homeowner called at 1:45 a.m. after hearing running water under the slab and seeing carpet soak through near the master bath. They had shut off the main but did not know where the leak was or how bad it would get.
We arrived by 3:15 a.m., confirmed a cold water line break with thermal imaging, isolated the line, and repaired it by 5 a.m. Pressure test held at 95 PSI. We patched the concrete and left the homeowner with a Final Check. Carpet was dried and saved.
A Whiffletree homeowner noticed a cracked tile and a musty smell near the baseboard. A handyman told them it was foundation movement. They called us for a second opinion before spending money on foundation work.
We detected a drain line leak under the slab with a RIDGID SeeSnake video inspection camera and acoustic gear. We repaired the PVC pipe through a small access cut, pressure tested, and patched the concrete. Musty smell cleared after drying. Foundation moisture returned to normal in two weeks.
Slab leaks show up in different ways depending on your home's age, pipe material, and soil conditions. Here are the most common problems we solve when someone calls us for professional slab leak repair in Plano Texas.
Ask a pro →We isolate the hot and cold lines with pressure testing kits and use acoustic listening devices to find the leak. Most high-bill slab leaks are found and repaired within one visit. Your bill drops back to normal the next billing cycle.
We trace the hot water line with thermal imaging cameras and electronic leak detection equipment. Once located, we repair the copper pipe or PEX tubing and pressure test it. Warm spots disappear within hours of the repair.
We use acoustic listening devices and pipe locators to follow the sound to its source. If the leak is in a drain line, we run a video inspection camera to confirm. We repair the line, test it, and patch the concrete the same day.
We detect the leak first, because fixing the pipe stops the soil from getting wetter. Then we repair the line and patch the slab. If the foundation has already moved, we tell you and refer a foundation specialist. We do not sell foundation work.
Slab leak fixing is repairing a water or drain line that runs beneath your concrete foundation. You need it if you see warm spots on the floor, hear running water when everything is off, or your water bill jumped 30% or more with no change in use. Plano's clay soil shifts and cracks copper pipe over time. Ignoring it leads to foundation moisture, mold growth from leaks, and cracked slab. Call us for detection before the damage spreads.
Sometimes, yes. If your pipe qualifies, we use trenchless repair equipment and epoxy pipe lining to reline or reroute the line with minimal concrete cutting. Many Plano homes still need a small access point, typically 12 to 18 inches wide, because the leak is at a joint or fitting that cannot be relined. We tell you which method applies after detection, before any work starts.
Most slab leak repairs take 4 to 8 hours from detection to patched concrete. Detection runs 45 to 90 minutes. The repair itself runs 2 to 4 hours for a direct access fix. If we reroute the line or the leak is under tile or hardwood, plan on a full day or a second day for flooring. We give you a timeline before we start and call if anything changes.
The best slab leak repair company Plano TX homeowners can call is one that detects before it demolishes, prices flat before it starts, and warrants the repair in writing. We hold Local licenses, use RIDGID SeeSnake and LeakTronics gear, and run 24/7 emergency calls. Ask any company for their license, their detection method, and their warranty. Then call us at +1 (972) 544-0575 and compare.
Slab Leak DetectionDetection always comes first. We use electronic leak detection equipment, acoustic listening devices, and thermal imaging cameras to pinpoint the leak before any concrete is cut. If you suspect a slab leak but are not sure, start here. Detection typically takes 45 to 90 minutes and saves you from unnecessary demolition.Explore →
Leak DetectionNot every leak is under the slab. Our general leak detection service covers walls, ceilings, and supply lines using pressure testing kits and moisture meters. If your slab leak turns out to be a wall leak or a fixture leak, we pivot without a second call-out fee. One visit, one answer.Explore →
Water Leak DetectionWater leaks waste hundreds of gallons a month and drive up your bill. We use moisture meters and thermal imaging cameras to trace water leaks from the meter to the fixture. For Plano homeowners with high water bills and no visible leak, this is the service that finds the source.Explore →
Electronic Leak DetectionElectronic leak detection is our primary tool for slab leaks. We inject a signal into the line and track it with a pipe locator and acoustic listening devices. It works on copper pipe, PEX tubing, and PVC pipe. This method finds leaks under tile, hardwood, and carpet without pulling up flooring.Explore →
Emergency Slab Leak RepairActive slab leaks do not wait. If water is pooling on your floor or you hear running water under the slab at 2 a.m., call +1 (972) 544-0575. We run 24/7 emergency slab leak repair with a live dispatcher. We will help you shut off the main and get a plumber to your door fast.Explore →
Pipe Leak RepairSlab leaks are pipe leaks. We repair copper pipe, PEX tubing, and PVC pipe with solder, pipe clamps, and pipe sealant as the material requires. If your leak is in a wall or attic line instead of under the slab, we handle that too. Same licensed plumbers, same flat pricing.Explore →
Underground Leak DetectionUnderground leaks cover sewer lines, irrigation lines, and main water lines outside the slab. We use video inspection cameras like RIDGID SeeSnake and SewerVUE to inspect buried lines. If your slab leak investigation points outside the foundation, this service finds it without digging up your yard.Explore →Every hour a slab leak runs, water moves under your foundation and into your flooring. We detect, repair, and test the same day in most cases. Local leak repair, and warrantied. Call +1 (972) 544-0575 for prompt service across Plano and Collin County.
Book a visit +1 (972) 544-0575 →Call us any hour at (972) 544-0575 for slab leak detection and repair in Plano. We answer 24/7, including holidays, and most detection visits are scheduled the same day. If water is actively running, we treat it as an emergency and dispatch immediately.